How to Install Artificial Grass yourself

Follow these simple Do-It-Yourself instructions to install ProLawn like a pro...
(click on image for full size elargement)

Step 1: Define and Measure
Define, paint and measure your potential turf area. Keeping in mind that turf comes in 15' widths, measure what your lineal footage of turf will be. All turf must be laid out in the same direction.

Step 2: Excavate
A minimum depth of 5" is suggested for base material and turf. Remove grass, dirt, or other materials to leave a 5" reveal inside all borders. Cap and/or remove any irrigation within the specified area, as required.

Step 3: Install Borders
Concrete curbing or polypropylene wood-flexd bender board are recommended, as they will last as long as the turf. Make sure your borders carry a warranty similar to that of the turf being installed.

Step 4: Primary Base Layer
Install 3/4" minus aggregate material at a minimum depth of 2". Rake out evenly, or to desired contour. Keep drainage and water flow in mind during this process. (1yd. of this material will cover 150 s.f. at depth of 2")

Step 5: Wet Down and Compact
Slightly wet the entire surface. Using a vibrating plate compactor, compact the surface several times. Repeat untill base is very hard.

Step 6: Leveling Layer
Install a leveling layer of decomposed granite (1/4" minus) at a depth of 1". Rake to desired grade and compact, as mentioned in the previous steps. (1yd. of this material will cover approximately 310 s.f. at a depth of 1")

Step 7: Roll, Tack, and Cut
Once base is completed, roll out turf and tack in place, using galvanized nails (16d or 40d), spikes, or landscape staples. Then cut turf into all perimeter borders as necessary. A carpet knife is recommended.

Step 8: Secure Perimeter
Secure the perimeter of the turf every 6"-12", using galvanized nails (16d or 40d), spikes, or landscape staples.

Step 9: Silica Sand
Using a drop spreader, like those used to distribute fertilizer, evenly distribute #20 grit silica sand over entire turf area. ProLawn recommends using between 1 lb. and 3 lbs. of silica sand to lend weight to the turf. This helps to prevent expansion and contraction of the turf during temperature changes.

Step 10: Brooming
Work the silica sand down into the fibers of the turf, by using a 24" stiff bristle, or coarse nylon push broom. If available, power brooms can make this step faster and easier.

Step 11: Enjoy your New ProLawn

Step 12: Tell one of your jealous friends to give us a call.

-